Error when programming Agilex

Hello everybody,
I’m am trying to program an Agilex™ F-Series board with my design in Quartus 21.3, but i get the following error:
Error (18950): Device has stopped receiving configuration data
Error (18948): Error message received from device: External hardware access error. (Subcode 0x0032, Info 0x00800008, Location 0x00001800)
Error (22248): Detected a PMBUS error during configuration. Potential errors: VID setting is incorrect in the Intel Quartus Prime project. The target device fails to communicate to a smart regulator or PMBUS master on a board.
Error (209012): Operation failed
Info (209061): Ended Programmer operation at Wed Jan 5 10:18:29 2022
Error: Quartus Prime Programmer was unsuccessful. 4 errors, 0 warnings
Error: Peak virtual memory: 3302 megabytes
Error: Processing ended: Wed Jan 5 10:18:29 2022
Error: Elapsed time: 00:01:09
Error: System process ID: 29607

Apparently i need to change the VID setting but i don’t know what to do.

Thanks in advance for your help!

make sure, your FPGA device is supported by that quatus version… !
and you selected the right device … at the start of project… !