Problem in Remote System Explorer Configuration for Linux Boot from QSPI

Hi,

I am booting Linux from QSPI Flash on Altera SoC Board. When I try to configure RSE for Linux Application Debug over Ethernet it is failing. The same is working fine if I boot Linux from SD Card.

I believe this problem is related to altera-minimal-rootfs which is customized to fit in QSPI Flash. The standard rootFS provided by altera is only for SD Card and cannot fit in 512 Mb QSPI Flash.

Kindly see attached snapshots and suggest the needful.

Regards
Sudhendra

you should install “SSH” or “vsftpd” package in your system, and run as a daemon. You can use “netstat -an” command to check if these network service port is open